SUPPLIES LIST + LINKS

-Vinyl: https://amzn.to/3eMQpqD 
-Crcut Machine: https://amzn.to/2BuClRv
-Light Grip Mat: https://amzn.to/3bdnvzh 
-Transfer Tape: https://amzn.to/3ba9ZfZ 
-Weeding & Scraper tools: https://amzn.to/31rtv39 
-Tumbler: https://amzn.to/3jqpO6b 
-Alcohol: https://amzn.to/2WG3OL1 
-Resin: https://counterculturediy.com/product/medium-viscosity-artist-resin-32oz/ 
-Stir Sticks: https://amzn.to/3hltzbn 
-Glitter: www.peachyoliveglitters.com 
-Sanding Block: https://amzn.to/3hltAMt 
-Spray Paint: https://amzn.to/30KbkpB 
-Mixing Cups: https://amzn.to/39eTU83 
-Gloves: https://amzn.to/3hqlnH3 
-Turner: https://www.etsy.com/listing/785399589/single-cup-turner-tumbler-with-drying?ga_order=most_relevant&ga_search_type=all&ga_view_type=gallery&ga_search_query=cup+turner&ref=sr_gallery-1-5&organic_search_click=1&frs=1

In part 2 of this tutorial we will dive into sanding, rim clean up, and adding vinyl decals.

1

Sand

2

Clean up the rim

3

Scuff up the bottom.

4

Feel for any areas that still need sanding

5

Use a true control knife to remove any drips from the inside of the cup.

6

Wipe with alcohol

7

Weed and transfer decal to transfer tape

8

Apply decal to tumbler

9

Add a thin top coat over decals. Without decals this could have been a final coat.

10

Sand smooth being cautious of any vinyl that hasn’t gotten fully covered.

11

Wipe with alcohol and allow to dry.

12

Mix and pour a final layer (fingers crossed! 🤞🏼)

There are so many ways you could do any 1 step so feel free to be creative & go with your own flow.

Check out my other content @JLcreativebyJoanna on Jumprope.

Disclosure: This article may contain affiliate links. When you click these links, I may get a small commission. It won’t cost you anything, but it helps me run this site. I only promote products and services that I think are great. I am an experienced crafter with a BSN degree, and I use my experience to judge whether a product is good enough or not.